12
②
Make holes on the front panel
③
Remote controller installation
④
Attach the front panel
1. Push the driver into the groove of the lower body of the remote control, and then remove the
lower case.
1. Replace front panel.
2. Fix the film to the front panel with the screw and washer.
3. Close the front panel.
4. Replace the two screws on the right side of the unit.
Make holes (x3) correctly at the following position. (2 screw holes, a wire hole)
2. Fixed the case of the remote control with screws onto the front panel.
3. Connect the remote control wiring to the main PCB of AHU kit.
4. Fit the body of the remote control to the lower case, and then install it.
Less than 180mm
Hole for remote
control
ler wiring
Φ
10mm
Hole for remote
control
ler wiring
2
×Φ
3.1mm
Hole for screws of remote
control
ler installation
Front view
If the hole position is wrong or
different, the electrical
equipment parts in the box and
the wires may be damaged and
cause the trouble.
Caution
Φ
10mm Hole
2
×Φ
3.1mm Hole
Top view
Use the two screws(4x8)
that come with this AHU
kit instead of the four
screws that come with the
remote controller.
Caution
Screw(4x8)
×
2
(Supplied
Parts)
Hole for remote
controller
installation
Hole for remote
control
ler wiring
Body of the
remote control
ler
Lower case of the
remote control
ler
Summary of Contents for CZ-280PAH1
Page 19: ...19 MEMO ...