2
INSTALLATION OF THE DECORATION PANEL TO THE
INDOOR UNIT BODY
〈〈
Refer to the installation manual attached to the indoor unit for the installation of the indoor unit.
〉〉
(1) Set the decoration panel to the indoor unit body by matching the position of the swing flap motor of the decoration panel to the piping position
of the indoor unit as shown in Fig. 4.
(2) Install the decoration panel
1
Temporarily install the decoration panel to the indoor unit by hanging the latch on the opposite side of the swing flap motor of the
decoration panel to the hook of the indoor unit body. (2 positions)
2
Temporarily hang the remaining 2 latches to the hooks on the sides of the indoor unit.
(Be careful not to let the swing motor lead wire get caught in the sealing material.)
3
Screw all 4 hexagon head screws located right
beneath the latches in approximately 5 mm.
(Panel will rise)
4
Adjust the decoration panel by turning it to the
arrowed direction in Fig. 4 so that the ceiling
opening is completely covered.
5
Tighten the screws until the thickness of the
sealing material between the decoration panel
and the indoor unit body reduces to 5–8 mm.
PRECAUTIONS
●
Inproper screwing of the screws may cause the troubles shown in
Fig. 5. Screw properly.
Decoration panel
5 – 8mm
Indoor unit
Ceiling material
Air outlet
Sealing material
Fig. 4
Hook
Latch
1
2
2
3
4
Piping position
Fig. 5
Contamination
Dew formation, dew dripping
Air leak
Air leak from ceiling
▲
▲
▲
▲
▲
▲
▲
▲
▲
Swing flap motor
BYC125-W1(8)-(E)
01.9.13, 8:56 AM
2
