Panasonic CZ-01ESM11P, Operation Manual

Page: 11 / 17

27
●
List of setting operation
A:
Zones not displayed
Display Setting Contents of setting
⳯
䡬
To be set by zone
䡬
To be set by zone
❈
1
䡬
To be set by zone
䡬
To be set by zone
䡬
To be set by zone
❈
1
䡬
To be set by zone
❈
1
Select this display if you
䡬
don’t wish to set by
zone.
B: Zones displayed
Display Setting Contents of setting
䡬 ❈
2
䡬
To be set by zone
⳯
⳯
⳯
䡬
To be set by zone
❈
1
䡬
❈
1
Select this display if you
䡬
don’t wish to set by
zone.
Note) In the above list, “
䡬
” refers to the acceptable
setting, while “
⳯
” refers to the not acceptable
setting.
In the meanwhile,
❈
1 and
❈
2 refer to the
followings.
❈
1: Setting may not be acceptable depending
on the type of indoor unit with which this
unit is connected.
SETTING OPERATION
MODE (Fig. 5)
●
The Zone consists of the following
two cases.
A. Zone without display “ ”
The group with master remote controller setting
exists in this zone.
Setting the master remote controller enables cool/
heat selection.
Operations other than cool/heat operations can
also be set for some operations. For further
details, see the list on the right.
B. Zone with display “ ”
No group with master remote controller setting
exists in this zone.
The cool/heat selection is not available because
the master remote controller has not been set.
Some operations other than cool/heat operations
can be set. For further details, see the list in the
right.
See page 31 if the display “ ” is flashing.
1
Press the OPERATION MODE
SELECTOR BUTTON. Each time
you press this button, the display
rotates as shown on the right list.
NOTES
●
During cool/heat operation, this central remote
controller enables FAN operation for each zone
even without setting the master remote controller.
Meanwhile, ventilation, ventilation/cleaning, etc. are
available, if UM etc. are connected with this unit in
the zone. See the operation manual provided with
the each unit.
●
When the indoor unit is in heat operation, change
the setting to FAN operation through the central
remote controller; then, you can switch the fan
speed to the extremely low fan speed. Warm air
may blow if any other indoor unit belonging to the
same system is in heat operation.
●
The indoor fan stops during defrost/hot start.
●
DRY cannot be set from the central remote control-
ler.
— —
▼
▼
▼
▼
▼
▼
▼
▼
— —
▼
▼
▼
▼
▼
▼
▼
▼