Panasonic CS-VE9NKE, Service Manual, Page: 100 / 140

100
8 Remove the earth wire screw (1 piece) and disconnect the indoor/outdoor connection wires as well as the
connector for the white wire connected to the terminal block. Then, remove the control board box.

Note on assembly: About lead wire arrangement during assembly

The lead wire of the indoor motor should be hung on the hook on the motor cover, then hung on the
hook on the ventilation fan, and then brought to the left. Connect the connector to the control board.

The lead wire from down side should be positioned along the ventilation fan, then hung on the hook
on the ventilation fan, and then brought to the left. Connect the connector to the control board.
16.1.5 Removing the Control Board
1 Perform “16.1.1 Removing the Front Panel”.
2 Perform “16.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.

Note on disassembly: When removing only the control board, remove the front grille (right) only.
3 Perform “16.1.4 Removing the Control Board Box”.
4 Disconnect the connectors for the black and red wires connected to the terminal block.
5 Remove the screw (1 piece) which fixes the control board.