36
11.2.4.2
Cutting and flaring the piping
1 Please cut using pipe cutter and then remove the burrs.
2 Remove the burrs by using reamer. If burrs are not removed, gas leakage may be caused. Turn the piping
end down to avoid the metal powder entering the pipe.
3 Please make flare after inserting the flare nut onto the copper pipes.
1. To cut
Improper flaring
Inclined
Surface
damaged
Cracked Uneven
thickness
3. To flare
Bar
Red arrow mark
Handle
Core
Yoke
Clamp handle
Bar
(0 – 0.5 mm)
0 – 1/32”
Copper
pipe
Reamer
2. To remove burrs
Point down
Pipe
When properly flared, the internal
surface of the flare will evenly
shine and be of even thickness.
Since the flare part comes into
contact with the connections,
carefully check the flare finish.
Summary of Contents for CS-RE9SKUA
Page 111: ...111 Figure 19 Figure 20...