Panasonic CS-MC12DKV, Service Manual

Page: 38 / 72

HOW TO TAKE OUT FRONT GRILLE
Please follow the steps below to take out front grille if
necessary such as when servicing.
1. Set the vertical airflow direction louver to the horizontal
position.
2. Slide down the 2 caps on the front grille as shown in the
illustration below, and then remove the 2 mounting screws.
3. Pull the lower section of the front grille towards you to
remove the front grille.
When reinstalling the front grille, first set the vertical
airflow direction louver to the horizontal position and
then carry out above steps 1 - 2 in the reverse order.
AUTO SWITCH OPERATION
The below operations will be performed by pressing the
“AUTO” switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the
Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING
PURPOSE)
The Test Run operation will be activated if the Auto Switch
is pressed continuously for more than 5 sec. A “pep” sound
will occur at the fifth sec., in order to identify the starting of
Test Run operation
3. REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote Controller receiving sound can be
change over by the following steps:
a. Release the Auto Switch after Test Run operation is
activated.
b. Then, within 20 sec. after (a), press Auto Switch for
more than 5 sec.
A “beep” “beep” sound will occur at the fifth sec., then
release the Auto switch.
c. Within 20 sec. after (b), press Auto Switch again.
Everytime Auto Switch is pressed (within 20 sec.
interval), remote controller receiving sound status will be
reversed between ON and OFF.
Long “beep” sound indicates that remote controller
receiving sound is OFF.
Short “beep” sound indicates that remote controller
receiving sound is ON.
38
CS-MC12DKV CU-2C24DKV