CQ-C3305N
10
CQ-C3305N
11
English
General
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
Power on
Press
[PWR]
(Power).
Power off
Hold down
[PWR]
(Power) for 1 sec. or
more.
You can remove the face plate to
prevent it from being stolen.
Removing
1
Turn off the power. (
above)
2
Press
[OPEN]
. The face plate will be
opened.
3
Push the face plate to
the left.
4
Pull it out toward you.
5
Put the face plate in
the case.
Cautions
• This face plate is not waterproof. Do not expose it to
water or excessive moisture.
• Do not remove the face plate while driving your car.
• Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high.
• Do not touch the contacts on the face plate or on
the main unit, since this may result in poor electrical
contacts.
• If dirt or other foreign substances get on the
contacts, wipe them off with clean and dry cloth.
• To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
Power On/off
(PWR: Power)
Face Plate Removing/Mounting
(Anti-Theft System)
Display Change
(DISP: Display)
The display changes as follows every time
[DISP]
is
pressed. (ACC ON)
At power-off:
Clock display (Default)
Display off
Mounting
1
Fit the face plate with its left hole on the
left pin provided on the main unit.
2
Fit the other hole on the other pin
applying slight pressure.
At power-on:
When the power is set to ON, refer to the description for
each source mode.
Volume off (down)
Press
[MUTE]
.
Cancel
Press
[MUTE]
again.
Note:
You can select mute or attenuation. (
page 27)
Up
Down
Setting Range: 0 to 40
Default: 18
Note:
The volume level can be set independently for
each source. (For radio, one volume setting for AM
(LW/MW), one volume setting for all FMs)
V
olume Adjustment
(VOLUME)
Te
mporar
y V
olume Off
(Down)
MUTE (A
TT
: Attenuation)
Caution
• Set the volume level to low enough before the
AUX connection is completed.
Failure to observe this, the loud noise may come
out and damage your speakers and your hearing.
The source changes as follows every time
[SOURCE]
is pressed.
AUX1
(AUX1 in) (3.5 mm
stereo)
From line output of external sound/audio device (ex.
Silicon-audio player, HDD player, etc.)
Radio
FM1, FM2, FM3, AM (
page 12)
Player
When loading CD (
page 18)
When loading MP3/WMA disc (
page 20)
AUX1
Device connected to the AUX1 terminal of this unit
When an optional device is connected:
Shift to connected device
When connecting CD changer
When connecting iPod
OR
When an expansion module is connected:
The devices connected to the ports 1 to 4 are
activated in sequence after shifting to AUX2 (device
connected to the AUX terminal of the expansion
module).
Note:
For information about connectable devices,
refer to the
System Upgrade Guidebook
or the
instruction manual for each device.
System-up Connector
Source Selection
(SOURCE)
