23
E
Check the settings by following the instructions in
“Preparations” (
page 9).
Is the drive properly mounted in the multimedia
pocket?
Restart the computer.
Is the disc loaded on the tray correctly?
(
page 9)
Is the disc bent, scratched, or dirty?
An error may occur if, after the tray has been closed
or operation has been resumed from the standby/
hibernation modes, the drive is accessed before the
Multimedia Pocket device status indicator
goes
off. Also, an error may occur if the drive is ac-
cessed by the application software automatically.
In a case like this, remove the disc, re-insert it, and
try again.
Install “DVD-RAM Driver”. (
page 14)
Is writing software other than “B’s Recorder” or
“B’s CLiP” installed?
Uninstall the writing software other than “B’s Re-
corder” or “B’s CLiP.”
Be sure to disable writing to CDs.
(
page 13)
Turn on the computer.
To remove a disc when the
computer is powered off,
insert a pointed object (e.g.,
the bent-out tip of a paper
clip, or the tip of a pencil or ballpoint pen) into the
emergency hole (A). Pushing it completely to the
end will free the tray so that it can be pulled out.
(The position of the emergency hole differs de-
pending on the drive.)
When using a software such as B’s CLiP that con-
trols the disc removal, remove the disc while re-
ferring to the software’s operating instructions.
If a disc with fingerprints or other dirt is used, you
may not be able to remove it. Use a clean disc.
(
page 8)
Do not touch the eject button when closing the tray.
Use another drive or media.
Troubleshooting
The computer does not recognize
the drive
The Multimedia pocket device
status indicator
does not light
Cannot play disc or read data
from it
“B’s Recorder” and “B’s CLiP”
do not work properly
Cannot eject disc
The disc tray does not close
Other disk operation problems
