12
z
Detaching the Cover
Detach the front cover from the iris camera by removing the
tamperproof screws with the supplied tamperproof screw
driver tool.
Note:
Be sure to shut down the power supply before
detaching the front cover from the iris camera. If the
power is being supplied when the front cover is
detached, the iris camera will enter the "tamper detec-
tion" mode and the buzzer will beep. In case the power
supply cannot be shut down, detach the front cover
from the camera and cancel the "tamper detection"
mode by moving Setup Switch 3 to ON. The buzzer
sound will be stopped.
x
Setup Switch Setting for Setup
Before starting the setup, move Setup Switch 3 to ON to
cancel the "tamper detection" mode. (Set all the other
switches to OFF.)
Tamperproof screws x 2
Approx. 15
°
The tamperproof screw holes are
inclined to the front side approx. 15
°
as you can easily fasten the screws
while the iris camera is mounted to the wall.
Remove the tamperproof screws with the
supplied tamperproof screw driver tool.
ON (Upper side)
1 2 3 4
c
Connection between the Iris Camera and
Setup PC
Connect the iris camera and setup PC with the exclusive
setup cable supplied to the administration software.
Attach the round connector of the cable to the setup cable
connector of the iris camera, and then attach the D-sub 9
pin connector of the cable to the serial port of Setup PC.
(When attaching the round connector to the iris camera,
direct the cable to the left of the connector.)
v
Supplying the Power to the Iris Camera
Turn on the power of the external power-supply device.
Wait until the guide and result indicator goes out.
b
System Setup
The following is how to boot the setup software.
1. Double-click "BM-ET300 SetupSoftware" in the
folder designated at the time of installation.
"BM-ET300 Login" window will appear.
2. Select the COM port to which the iris camera is
connected, and then enter the password.
• Available characters (Capital and small letters are dis-
tinct.): ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghij
klmnopqrstuvwxyz0123456789
• 6 to 16 characters are available.
• Default password: BMET300
When the password is accepted, the current setting is
read from the iris camera into the setup software. (The
reading may take a few seconds.)
After the setting is read into the software, the
"Completed." window will appear. When you click on
"OK", the "BM-ET300 setup software" window will
appear. (Refer to p. 13.)
