10
Operation mode change:
Switch 1 changes the iris
camera between the “normal operation” mode and
“setup” mode. Before setup, set this switch to OFF.
Booting program change:
Switch 2 changes the boot-
ing program used by the iris camera. When the
program installed in the iris camera cannot boot the
iris camera, set this switch to ON and supply the
power again. The factory default program will boot
the iris camera. (Normally, set the switch to OFF.)
“Tamper detection” mode activation/cancellation:
Switch 3 cancels the "tamper detection" mode acti-
vated by the front/rear tamper detection switch.
When the "tamper detection" mode is cancelled, the
buzzer sound will stop and setup becomes avail-
able.
Note:
Before closing the cover, set Switch 3 to OFF. If
the cover is attached while the switch is set to ON,
the iris camera cannot work properly.
y
Tamper detection buzzer volume controller
This controller is used for adjusting the sound level of
buzzer, which is output while the "tamper detection"
mode is activated.
Note:
Avoid adding excessive force to the controller.
That may cause damage.
