Installation/Troubleshooting
[For assistance, please call: 1-800-272-7033] 67
Troubleshooting
2.10 IPsec
Problem
Cause and Remedy
The camera
cannot be
accessed in
transport mode.
• IPsec policy settings are restricted.
Decrease the number of computers connected
simultaneously, and wait for a while, or shorten the lifetime in
the PC's IPsec settings.
• IPsec settings have not been set on your PC.
Set IPsec settings on your PC. See the Panasonic Network
Camera support website (http://panasonic.co.jp/pcc/
products/en/netwkcam/) for how to do this.
• The pre-shared key is not set correctly.
Set the same pre-shared key for the camera and your PC
(see page 54 of Operating Instructions on the Setup CD-
ROM).
• On the VPN router within the network, tunnel mode has been
set.
Transport mode and tunnel mode can not be used at the
same time. Cancel the PC's IPsec settings, and
communicate using tunnel mode.
• Either PC's SA
*1
or Camera's SA is not established.
*1
SA (Security Association) refers to establishing a secure connection for an encrypted
communication that uses IPsec or IPv6 by exchanging and sharing information such as the
encryption scheme and key before communicating, or refers to an established virtual
encrypted communication pathway.
Disable the PC's IPsec settings, and enable it again.