Panasonic AW-PH500p, Operating Instructions Manual

Page: 12 / 20

12
Pin No Signal
24, A DC 12 V
6, 8, B GND
4 DC 12 V
1 GND
17, 19 GND
1 VIDEO
2 GND
23 G/L
21 T/R
5 R/P
R
/C
4 G/Y/Y
7 B/P
B
∞
Use a 1.5C-2V coaxial cable for the video and camera control signals.
∞
Provide cables with a nominal cross-sectional area of 0.3 mm
2
or more that comply with the Electrical Appliance and
Material Control Law for the DC power supply and GND (connected using 4-pin Cannon connectors).
¥
Cable wiring diagram
Connections
<Note>
∞
Provide the cable shown in the figure described below to connect the camera with the pan/tilt head (
¢
1). Make the cable
long enough to support the connection when the camera is attached to the pan/tilt head and the pan/tilt head is moved
upward and downward. (Approx. 60 cm: This length differs depending on the camera which is attached and the positions of
the camera’s connectors.)
26-pin connector, female,
SRCB06A21-26S made by
Nihon Denshi Kogyo
To camera’s 26-
pin connector
To pan/tilt head’s CAMERA
POWER OUT connector
To pan/tilt head’s VIDEO
IN connector
To pan/tilt head’s G/L
IN connector
To pan/tilt head’s CAMERA
CONTROL OUT connector
To pan/tilt head’s COMPONENT
INPUT connector
DC 12 V
4-pin Cannon connector,
male
BNC connector
BNC connector
BNC connector
9-pin D-sub connector,
male
VIDEO
G/L
CAMERA CONTROL
COMPONENT
26-pin connector
Pin No Signal
4-pin Cannon connector
Conductor VIDEO
Shell GND
Pin No Signal
BNC connector
Conductor G/L
Shell GND
Pin No Signal
BNC connector
Conductor CAMERA CONT
Shell GND
Pin No Signal
BNC connector
1 R GND
2 G GND
3 R/P
R
/C
4 G/Y/Y
5 B/P
B
8 B GND
Pin No Signal
BNC connector
<Note>
When a motorized zoom lens is used, and its zoom/focus functions are to be controlled from the pan-tilt control panel, select
a cable which is long enough to support the connections when the pan/tilt head is moved upward and downward, as with the
cables listed above. (Recommended cable: S14
a
7.5BMD-D24 made by Fujinon)