Panasonic AV-HS60C1E, Operation Manual

Page: 138 / 206

– 138 –
Chapter 7 CONFIG Menu — Setting the operation mode
Switching the ME area in multi‑selection panel area
You can switch ME areas through the multi-selection panel area.
For basic operations of the multi-selection panel area, refer to “Basic operations for the multi-selection panel area” (page 40).
1
Press the <ME CHG> button.
f
The display of the multi-selection panel area changes as follows:
S1 Blank ―
S2 Current ME line
Displays the ME line to which the corresponding multi-
selection panel area belongs.
S3 Blank ―
1 ME1 The current ME line is displayed in red.
2 ME2 The current ME line is displayed in red.
3 to 12 Blank ―
2
In the multi‑selection panel area, hold down the button (1 or 2) that displays the target ME line.
f
If you press the button that displays an ME line that is different from the current ME line, the ME line will be switched.
Key source preset settings
The key source preset is a function that stores (presents) key settings in memory for each keyer and each source.
If a key source is selected using the KEY bus crosspoint buttons of the control panel, a preset is automatically recalled. Also, if the key settings are
changed, each preset is automatically overwritten.
The following settings are stored in memory for each preset:
f
KEY1 to KEY4 of ME1 and ME2
- All settings of the <ME1>/<ME2> button on the top menu → [KEY1] to [KEY4] → [Key Setting] tab
- Settings of the <ME1>/<ME2> button on the top menu → [KEY1] to [KEY4] → [Chroma] tab → [Adjust] column
- Settings that disable the chroma key
f
DSK1 to DSK4
- All settings of the <DSK MISC> button on the top menu → [DSK1] to [DSK4] → [Setting] tab
Key source preset operation settings
1
Select the <CONF> button → [OPERATE] → [Key] tab.
2
Select an item in [Source Preset] in the [Key Source Preset] column.
[Enable]
Enables the key source preset function.
Stores the settings in memory by each keyer and each source.
[Disable]
Disables the key source preset function.
The preset is not recalled even if the source is switched.
3
Select an item in [Keyer Link] in the [Key Source Preset] column.
f
Select the keyer link setting for the source preset.
[Enable]
Links key source presets between keyers.
If the selected source is the same, the same settings are applied, even if the keyers are different. However, a link is not
established between KEY1 and KEY4, and between DSK1 and DSK4 of ME.
[Disable]
Stores key source presets individually by each keyer and each source.
If the same source is selected using a different keyer, different settings are applied for each.
@ @ NOTE
t
When [Disable] is selected in the [Source Preset] item, operation is performed with keyer link settings in [Disable], regardless of the [Keyer Link] item
selection status.