Panasonic AV-HS6000, Operation Manual

Page: 29 / 206

– 29 –
Chapter 3 Part Names and Functions — Control Panel AV‑HS60C1/AV‑HS60C2/AV‑HS60C4
8 <COM2 (RS‑232)> terminal (connector: D‑sub 9‑pin (male), inch screw/signal: RS‑232)
Used to control external device. (page 171)
9 <GPI I/O> terminal (connector: D‑sub 25‑pin (female), inch screw/signal: GPI)
Equipped with 8 contact input ports (GPI IN) that control the unit externally, 10 output ports (GPI OUT) that output tallies or status information from
the unit, and an alarm output port (ALARM OUT). (page 170)
10 <F1>/<F2> terminals
(Fuse)
11 <SIGNAL GND> terminal (signal: SG)
Connects to the ground of the system.
@ @ NOTE
t
For the cable connecting to the <DVI-D> terminal, use a double-shielded cable.
t
For the cable connecting to the <MAIN FRAME> terminal, <COM1 (M)>/<COM2 (RS-232)> terminal, and <GPI I/O> terminal, use a shielded cable.
t
The <COM1 (M)> terminal and the <COM2 (RS-232)> terminal cannot be used with the sub control panel.
Side (right)
r
AV‑HS60C1/AV‑HS60C2
12
(Front) (Rear)
r
AV‑HS60C4
1 2
(Front) (Rear)
1 Reset switch
The reset switch for the Control Panel. (For maintenance)
2 Service switch
The switch for maintenance. Normally use it by setting to forward.