6.4.3 Auto-Talk-Lock setup (for only one headset)
When a customer approaches the menu board, it is automatically possible to make the predetermined personnel’s
headset (Order Taker or All-in-One Headset) stay in TALK state. (The Talk Lock Mode is assumed.) In regard to the
method of Auto Talk Lock Mode setup, refer to the operating instructions of the Order Taker (WX-T3020) or the All-in-One
Headset (WX-H3050).
For a headset where Auto-Talk-Lock is set up, it has a function to select [Talk] automatically when the vehicle detector
has become active, and you can talk with the customer at the menu board.
1. Confirm that the DIP Switch 1 of the headset is ON, the DIP Switch 2 is set at the objective lane, and the power of the
headset is OFF.
Order Taker Unit
(WX-T3020)
All in One Headset
(WX-H3050)
2. Turn on the headset. The message "Hello Headset **" (** is the number of headset) is output from the speaker of the
headset, and the power indicator blinks green and red alternately for 3 seconds. While the indicator is blinking, press the
T1 or T2 button. (LANE A: T1 button, LANE B: T2 button) Auto-Talk-Lock will be set up, The message "Auto-Talk- Lock
ON" is heard from the speaker of the headset. When the T1 or T2 button is not pressed, the headset assumes an ordinary
operation mode.
3. In the case of a failure in Auto-Talk-Lock setup, a voice of [Failed] is heard from the speaker of the headset. In this case,
the same procedures should be followed from Step 1 again.
Note:
If the power of the headset is turned OFF, all the setting conditions for Auto-Talk-Lock will be canceled. This setting
should be carried out without fail when the power supply is started up.