8 – 70
Aquarea air/water heat pump – Installation manual for monobloc and split systems C, D and E series 05 / 2014
Electrical installation
Installing the wired remote control
Connection to the monobloc unit
1
Remote control cable
2
Chamber front panel
Laying the cable into the device
➤
Cut into the cable gland in a cross shape using a knife .
➤
Route the cables through the enclosed cable gland on the right side
of the housing to prevent the cables being damaged by sharp edges .
➤
Remove the dummy connection from the CN-REMOTE2 connection .
➤
Connect the wired remote control cable to the CN-REMOTE2 connec-
tion . Ensure it is attached securely .
➤
Secure the cable using cable ties as shown in the figure . Ensure that
the cables cannot come into contact with hot device parts .
2
1
8.4.3 Connection to the monobloc unit
➤
If necessary, open the monobloc unit as described in section 5 .1 .
1
2
3
4
1
Remote control cable
2
CNREMOTE2 connection
3
Cable ties
4
Cable gland
