18
Filter Menu
The
FILTER
menu is activated by pushing the
FILTER
button on the UFC front panel. This menu allows the user to
select the filtering and enhancement responses for the system. The user may select different responses or
enhancement settings depending upon the type of conversion being done (up or down) or the nature of the source
material (soft material may need more enhancement, noisy material may need less).
F I L T E R
H
R E S P
V
R E S P
H
E N H
V
E N H
2 - D
E N H
F1
F2
F3
F4
F5
EXIT
F1 – Activates knob to select the horizontal filter response (Wide, Standard, or Narrow).
F2 – Activates knob to select the vertical filter response (Wide, Standard, or Narrow).
F3 – Activates knob to select the amount of horizontal enhancement (0 to +6dB in 0.5dB steps).
F4 – Activates knob to select the amount of vertical enhancement (0 to +6dB in 0.5dB steps).
F5 – Activates knob to select the amount of two-dimensional enhancement (0 to +7dB in 1dB steps).
Note: H ENH and V ENH operate on the input format during the band-limiting process while 2-D ENH operates
on the output format. H ENH and V ENH have upper mid-band peaks while 2-D ENH has its peak at the
upper band edge.
Timing Menu
The
TIMING
menu is activated by pushing the
TIMING
button on the UFC front panel. The
SYSTEM
menu allows
the user to select the sync reference for the system, as well as the type of sync used for the genlock output (bi-level
or tri-level). Timing of the output video with respect to sync may also be adjusted by line (line advance) or by
sample (horizontal position). If the horizontal position exceeds the total number of samples per output line; line
advance will automatically be increased by one, and the horizontal position will be reset to zero.
The
FILM MODE
menu allows for selection of a 3:2 reference, if applicable and allows for offsetting the film frame
position that is referenced. When time code is used as a reference, the hour that is used as the synchronization point
may also be set.
SYSTEM
T I M I N G
> >
S Y S T E M
R E F
I N
G L
T Y P E
L I N
A D V
S Y S
H
F1
F2
F3
F4
F5
EXIT
F1 – Activates knob to select the sync reference (Input, External Bi-Level, External Tri-Level, or Black Burst).
F2 – Activates knob to select the genlock output sync type (Bi-Level or Tri-Level).
F3 – Activates knob to select the line advance value (0-7H).
F4 – Activates knob to select the horizontal position value (0-1H).
Note: If an external sync source is selected, the video input must be vertically locked to the same source.
