E-4
ENG
L
IS
H
Installation in AJ-HPX3100G
1
Make sure that the power of AJ-HPX3100G
is turned OFF. Confirm that there is no
battery, or no input to the DC IN terminal.
2
Remove the two screws (A: 3.0 mm diameter black
screws) from the bottom of the AJ-HPX3100G.
3
Remove six screws (A) on the left side
viewed from the front of the AJ-HPX3100G,
and remove the L side panel. Be careful not
to put load on the wires or connectors when
you remove the L side panel.
4
Remove one screw (B: 2.6 mm diameter
silver screw) from the inside of the left side.
5
Remove five screws (A) and four screws (C:
2.6 mm diameter black screws) on the right
side viewed from the front of the AJ-
HPX3100G, and then remove the R side
panel. Be careful not to put load on the wires
and FFC when you remove the R side panel.
6
Remove the four screws (B) mounted on the
PB COVER.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock do not perform any servicing other than as directed in the operating instructions
unless you are qualified to do so.
Screws (A)
Screws
(A)
Screws (B)
Wire bundle
Connectors
Screws (C)
Screws (A)
PB
COVER
Screws
(B)
FFC
Wire bundle
FFC
AJ-YDX30G(VQT3L98)_EJ.book 4 ページ ２０１２年４月１２日 木曜日 午後５時３７分
