- 18 -
Switches
SW2
ON
OFF
8
7
6
5
4
3
2
1
BS DIGITAL board
SW2-1: Y/G, PB/B, PR/R selector switch
ON: Y, PB, PR output
OFF:G, B, R output
SW2-6: Color bar setting selector switch
ON: SNG color bar
OFF:SMPTE/FULL color bar
<Note>
When selecting the positions of the above switches, make sure that you do not change the positions of the other switches indicated
with the broken lines by touching them by mistake.
The front cover must be removed in order to select the dynamic
microphone or carbon microphone setting.
Refer to the diagram below to perform the selection.
<Note>
The unit was shipped from the factory with the dynamic microphone
selected for this setting.
Carbon
microphone
Dynamic
microphone
PUSH
Setting the microswitch position
CONT
FRONT
RCOP
RCOP
Front panel
Select the front panel or controller connected to the OP3 connector for
the controller. Refer to the figure at the bottom right when making this
selection.
<Note>
Turn off the unit’s power before making the selection.
Switching the controller
Setting the board switch positions
CAUTIONS:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric
shock do not perform any servicing other than that
contained in the operating instructions unless you are
qualified to do so.
