Panasonic AIG707WCL1G2, User Manual

Page: 7 / 54

Before You Start

Touch switches
• Always operate the touch switches with fingers. As the touch switches may be damaged due
to the excessive load or shock (caused when being operated with any tools), the touch
switches should be operated within the specified control force. Also, if the touch switches are
pressed like kneading, the electrode may be worn out exceptionally, and cause the
malfunction. Operate with a single touch of a switch.
• When touching the ends of top, bottom, right and left of a touch switch, a position more
inside than the touched position may react. Therefore, do not place a switch smaller than 20
dots at the ends of the screen.
• The touch position may shift due to aging variation. If the touch position has shifted, please
adjust it.

LCD panel
• Do not drop or have a strong impact on the programmable display unit as glass is used for
the LCD panel.
• The liquid in the LCD panel is a hazardous substance. If the LCD panel is broken, do not put
the leaked crystalline liquid into your mouse. Should it get into your mouse, immediately
gargle, and consult a doctor. If it adheres to your skin or clothes, wash it away with soap.
• On the LCD panel, bright spots ( points always lit) or black spots (points always unlit) may
appear, or the uneven brightness, flickers or crosstalk (appearance of unintended shades in
the area no graphic or part is arranged) may occur depending on the operating conditions.
Note that these phenomena are resulted from the basic characteristics of LCD panel not
defects or failures of the product.

Battery
• Do not leave the battery in the unit when it is not used. There is a possibility of leak if it si left
being discharged.

Scratch protection sheet
• A sheet is affixed to the touch panel to protect it from scrathes when shipping.Please remove
it before using the GT.

Cautions on handling a SD memory card
• The data saved in the SD memory card may be lost in the following cases. We assume no
responsibility whatsoever for the lost of saved data.
1
）
When a user or third party used the SD memory card incorrectly.
2
）
When the SD memory card was affected by any static electricity or electrical noise.
3
）
When the SD memory card was removed or the power supply of the GT unit was turned off
while data was being read, written or deleted to/from the SD memory card.
• It is recommended to save important data in another media for backup.
v