13
Part Names and Functions
Front Panel
1. POWER switch
This is the main power switch when using an AC power
supply. It does not work when using a DC power supply.
2. POWER lamp
This indicates that the main power supply (AC power
supply) is turned on.
3. OPERATE lamp
This indicates that this unit is operating.
It will be as follows depending on the operation status of
this unit.
Light off:
This indicates that main power supply is
off or that the unit is initializing after the
power has been switched on.
Green light:
This indicates that it is in normal
operation status.
Green flashing:
This indicates the lock is being acquired
by this unit, the camera adapter, or the
camera recorder in cases such as right
after power on.
Red flashing:
This indicates that the cables between
this unit and the camera adapter or the
cables between the camera adapter and
the camera recorder (
1
,
2
,
3
,
4
, or
5
on page 8) are not connected or there is
a break in the cables. Check and
reconnect the cables, and then turn the
power of this unit OFF once and turn it
back ON.
Red light:
This indicates that the fan motor is not
revolving. If the fan stops turning during
normal operation or otherwise behaves
abnormally, consult a dealer.
4. INCOM connector
Connect the headset for the intercom.
Only a dynamic microphone can be used.
Use a 3-meters or less cable.
5. INCOM volume level potentiometer
This is a potentiometer to adjust the volume level of the
intercom.
6. MIC switch
This is the ON/OFF switch for the intercom microphone.
There are three positions: ON/OFF/PTT*.
*PTT (Push To talk): Microphone is turned on only while
pushed.)
7. TALLY lamp/CALL switch
This is turned on while the TALLY signal is input to this
unit. The TALLY lamp on the camera adapter will be
turned on while this is pressed.
TALLY lamp on the camera adapter and the TALLY lamp
connected to the VF OUT connector of the camera
adapter will be turned on when the TALLY signal is input
to this unit, and there will be no change even if the CALL
switch is pressed.
<Note>
The viewfinder connected to the VF connector of the
camera recorder will not turn on even if the CALL switch
is pressed.
With camera recorders that can mount the viewfinder
interface box (AG-YA500G; optional), it can be lighted
up after mounting. However, it will also light up when the
connected camera recorder is recording, so there will be
no change even when the CALL switch is pushed.
8. MENU switch
This is a switch to open the MENU to change the setting
of this unit. Push for 3 seconds or more.
9. SEL switch
This is a switch to select the settings of this unit from the
MENU of this unit.
ON
OFF
PIT
INCOM
INCOM
Base Station AG-BS300
OPERATE
ON
OFF
POWER
TALLY/CALL
MENU
MIC
ON
SEL
LEVEL
PUSH
1
2
3
4
5
6
7
8
9
AG-BS300P_E(VQT2H41)_E.book 13 ページ 2009年10月23日 金曜日 午後6時8分