panas TX-51P100H, Service Manual

Page: 11 / 108

- 11 -
9. Note position of yoke with centering tabs and
remove from defective CRT.
10. From the Top, remove (2) screws from the defec-
tive CRT.
11. Release CRT anode lead from CRT chassis wire
clamp and all other wires from holders.
12. Wire the anode lead wire.
13. Lift out CRT assembly with lens assembly and
other CRT neck assemblies.
14. Lay CRT face down on a soft cloth.
15. Remove CRT lens by removing (4) screws.
16. Install yoke and VM coil with other CRT neck
assemblies on CRT neck in the same order and
position as removed from the defective CRT.
17. Push yoke against bell of CRT and tighten the
clamp just snug enough so it will not easily shift.
18. Assemble CRT focus lens assembly to new CRT
with (4) screws. Make sure focus lens adjustment
nut is in the same location as on other CRT focus
lens.
Note: Please assemble with screws in the order
shown in detail and tighten with same torque.
(2) Screws
(for fixing CRT)
×
3
Front
(4) Screws (for fixing CRT)
1 4
2 3
All manuals and user guides at all-guides.com
all-guides.com