Panametrics PT878GC, Instruction Manual

Page: 105 / 224

TransPort™ PT878GC User’s Manual 95
Chapter 6.
6.1.5.1 Specifying the Number of Displayed Parameters
As mentioned earlier, the PT878GC can display one to four different measurement parameters simultaneously.
However, sometimes you might wish to display only one or two parameters. To change the number of open display
windows:
1. Press [MENU] .
2. From the Site Menu (shown in Figure 91 above), use the [

]or [

] arrow keys to move to the desired number of
views (1 View, 2 Views, etc.) Press [ENTER] .
The screen displays the designated number of windows. For example, Figure 92 below shows the screen displayed in
Figure 6-3 on page 6-4, reconfigured for a single view.
Figure 92: Display Screen Configured for Single View
Note: The PT878GC opens display windows from the top; that is, if you press “1 View,” one parameter appears. If
you press “2 Views,” two parameters appear, one on the top and one on the bottom. The view for “3 Views”
adds a window in the lower right, and that for “4 Views” sends the second parameter to the upper right
corner, with the third parameter in the lower left and the fourth parameter in the lower right.
2000/11/30 09:53 AM
Velocity, ft/s
E0: No Errors
ABC.SIT
12.2
-12.2
10 Seconds
-0.6014