Chapter 1. Programming Site Data
12
DigitalFlow™ DF868 Multipurpose Ultrasonic Liquid Flowmeter Programming Manual (2-Channel)
1.6.2.1
Mass Flow
If the
Mass Flow
prompt in the
SETUP
submenu is not enabled, skip this sub-section. However, the following
programming sequence appears if
Mass Flow
is enabled.
1.
Press
[F1]-[F4]
to select the desired
Mass Flow
units for the flow rate display
.
Note:
The option bar above shows English units, as an example. If Metric units were specified, these appear
instead.
The abbreviations and definitions of all the available mass flow units are shown in Table 4. The choices shown on the
option bar are determined by the selections made at the
SYSTEM UNITS
prompt.
2.
Press
[F1]-[F4]
to select the desired
Time
units for the mass flow rate display.
3.
Press
[F1]-[F4]
to select the desired number of
Decimal Digits
(digits to the right of the decimal point) in the
mass flow rate display.
4.
Press
[F1]-[F4]
to select the desired
Totalizer Units
for the totalized mass flow display
.
Note:
The option bar above shows English units, as an example. If Metric units were specified, these appear
instead.
The available mass flow units are shown in Table 4. The choices shown on the option bar are determined by the
selections made at the
SYSTEM UNITS
prompt.
5.
Press
[F1]-[F4]
to select the desired number of
Decimal Digits
(digits to the right of the decimal point) in the
totalized mass flow display.
Table 4: Available Mass Flow Units
English
Metric
LB = Pounds
KG = Kilograms
KLB = Thousands of LB
TONNE = Metric Tons (1000 KG)
MMLB = Millions of LB
TONS = Tons (2000 LB)