4
ASSEMBLY INSTRUCTIONS
CONTENTS OF THE BOX:
1 stove
1 extractor hood
1 flue (in 2 parts)
1 bag with 8 8 nuts + 1 key
WE RECOMMEND THAT ASSEMBLY IS DONE BY TWO PEOPLE
WEARING PROTECTIVE GLOVES
1. Open the box, lift out the extractor hood and place it on the floor.
2. Place the two parts of the flue on the bubble wrap with which they were packaged,
or alternatively on carpet or plastic. Place them with the grooves facing up to form a
‘U’ shape. Avoid direct contact with the floor so that they do not scratch it during the
assembly process.
3. Place the stove in the location in which it will be installed.
4. Place the tube over the smoke outlet flue and make the final connection of the outlet flue
to the ceiling (This tube is not included in the box).
5. Measure the distance from the floor to the ceiling and then subtract 1,29 m from this
measurement and write down the final result. The assembly of the two flue parts must
match this result or be a millimetre or so less (but no more).
6. Assemble the two parts of the flue at the part that does not contain the 2 bottom holes.
ATTENTION: when doing the assembly, do it gently without
assembling more than the necessary degree (because
otherwise when you remove the part from the flue, it could
scratch it).
7. Insert the 4 screws into the last groove on the bottom of the flue (where there are 2 holes)
at the two ends and screw them in tightly.
8. After assembled, take the assembled flue and place with part with the 2 holes facing
down on the extractor hood. First insert the 2 screws into the 2 ends of the grooves at
the front part of the flue, screw them in tightly and, secondly, insert the other 2 screws
into the 2 ends of the grooves at the back of the flue.
9. With two people and working very carefully, place the hood + flue set onto the stove
leaning slightly forward. Directly below the hood there are metal flanges on both sides
(in the front and back part of the hood) that are used to guide the hood. Using these
flanges, slide it towards the back of the stove. When you reach the metal flanges at the
front of the hood, lift it slightly so that it fits correctly.
Summary of Contents for CANADA
Page 39: ...37 Mod C A N A D A 39 1m...