© Pan Acoustics GmbH
V 1.0
Page 14 of 24
Manual
Step 1:
Insert the stripped wires into pin 2 and pin 5 of
the connection terminal. To do this, open the
screw blocks with a screwdriver. After insert-
ing the wires, close the screw blocks again and
tighten them with a torque of 0.4 Nm so that
the wires cannot slip out.
The wires of the connection cable must be fi tted
with wire end ferrules.
NOTICE
8.2.3.2. Power tapping 50%
Step 2:
Insert the connection terminal with the cable
into the 5-pin connector on the loudspeaker.
