© Pan Acoustics GmbH
V 1.0
Page 7 of 18
Manual
8. Assembly and connection
8.1. Assembly of mounts (accessories)
Various mounts are available from the “Pan Accessories” range for installing the loudspeaker on walls
and ceilings
--> see chapter 16 “Mounts”.
The installation and commissioning of loudspeakers must only be carried out by qualifi ed personnel.
Ensure that the mount chosen corresponds to the requirements on the wall or ceiling structure, along
with operating requirements.
National safety regulations for operation and assembly must be followed.
CONNECTION WITH THE BUILDING STRUCTURE
•
It must be ensured that the ceiling/wall area where the device is to be installed is structurally
suitable.
•
The mount must lie fl at on the surface of the building structure. The surface must not show any
settlement eff ects even in the long term.
•
For a safe and durable connection, plug and screw connections must be dimensioned according to
the acting forces that may occur through lever eff ects.
•
In case of doubt as to the type and composition of the building structure, consult a structural engineer.
CONNECTION OF THE LOUDSPEAKER AND MOUNT
•
All mounts sourced via Pan Acoustics for the Pan Speaker series are delivered with suitable instal-
lation material for connection with the loudspeaker.
•
The connection between the loudspeaker and the mount is made by a fi xing point (e.g. a slot nut,
which is inserted into the rear slot of the loudspeaker and tightened with two M6 set screws).The
mB variant of the loudspeaker features a U-bracket, which is mounted via a fi xing point in the lids
of the loudspeaker.
•
To avoid damage to the mounts and the loudspeakers, no screws longer than the original ones
must be used. Longer screws may destroy the stability of the loudspeaker or cause short circuits
inside the loudspeaker.
•
A tightening torque of 10 Nm must be observed for the screw connection between the mount and
the loudspeaker.
You can fi nd the installation instructions for the selected mount on our website in the download area.
NOTICE
