15 170311R2
Understanding LED indicators.
When first used PNGD will automatically create a data and event folders, LED's will be flashing
during the setup process this will not take long.
- After creating the setup file, the PNGD start to adjust the X,Y,Z default value of GPS.
This process may take about one minute.
- A few seconds after adjusting the GPS default value, the voice command will announce “recording”
and start to record the video in general mode.
a) GPS signal.
b) Audio on.
c) Camera's on.
d) Power on/ sense a G shock.
8.
If the setup file has already been created previously then PNGD will automatically begin recordings
affirmed by announcement “recording”.
a) Blank GPS light indicates no GPS.
9.
All LED's blue as below everything working OK. If all LED flashing possibly missing SD Card.
10.
Red power LED indicates G-sensor detected a certain level impact, it will save the footage in Event
folder.
11.
Red power LED could also be triggered by pressing the Emergency button, footage will be saved in
Event folder.
12.
(In case of Emergency powered by Cigarette socket jack only) when power off to adapter is lost, the
“safe back home” this is back up mode will be started after a few seconds and run for one minute with
voice command.
- If the Cigar jack is disconnected the POWER LED will be blinking in blue color.
- If the Cigar jack is connected, POWER LED is blinking in red color.
Voice command: “Change to Parking Mode”
