7
Lift the HV transformer and tilt
it as shown in the picture. Gently
lower the transformer until the
side with the connector is resting
on the amplifier chassis.
Make sure that none of the wir-
ing is pinched under the trans-
former.
While supporting the raised side of
the transformer, gently lower it in
place until it, too, is resting on the
chassis. The large opening in the
side of the chassis allows access to
do this.
The transformer is now in place
and can be fastened to the chassis.
Insert the provided carriage bolts
in from the top, through the trans-
former mounting tabs and chassis
slots. Next, slightly lift the chas-
sis and place a flat washer and
KEPS nut on the bottom side of
each bolt and tighten.
Caution: before tightening,
be sure that none of the wir-
ing harness is pinched under
the transformer!
