Paloma PG-311F Installation Instructions Manual Download Page 4

 

4

 
 

  5.9 Star Energy rating. 

  One touch ON/OFF button.  

 Electronic 

ignition. 

  Room temperature adjustment (Refer Page 7). 

  Economy function (Refer Page 8).  

  Filter Clean Warning Device - When the air filter is clogged or hot-air outlet is blocked, the filter safety 

device will switch off the heater and the filter light will flash. 

  Anti-tilt Safety Switch automatically shuts off gas flow if the heater is knocked or bumped. 

  Oxygen Depletion Safety System automatically shuts off gas flow if the oxygen level in the room drops 

below a safe level.  

  Flame Failure Device prevents flow of gas to burner if ignition fails or flame goes out. 

  Power Failure Device prevents flow of gas to burner if there is a power failure. 

  Overheat Safety Device – if the fan stops rotating for any reason the overheat switch shuts off the gas 

supply. 

  Manufactured in Japan. 

 

 
 
 
 

MODEL

PG-311F

PG-S311F

Type

Convection Heater 

Convection Heater

DIMENSIONS: (mm) 

436 x 531 x 206

436 x 531 x 206

(Approx: Height x Width x Depth)

GAS INPUT

LPG & NG

LPG & NG

High (MJ/h)

13.5

13.5

Low (MJ/h)

5.2

5.2

Output (kW)

3.4

3.4

HOSE Connections (mm)

Φ

 9.5

Φ

 9.5

STAR ENERGY RATING

5.9

5.9

MINIMUM ROOM SIZING (Cu.M)

33

33

COLOUR

Off White

Silver

NET WEIGHT (KGS)

10.9

10.9

 

 

 
 
 
 

(1)  Remove heater from carton. 
(2)  Please ensure that the gas specified on the rating plate matches your gas supply. Using a different type 

of gas may cause an explosive ignition resulting in injury, damage to heater or malfunction of the oxygen 
depletion safety system. Do not install heater if it is the wrong gas type. Please contact your place of 
purchase immediately. 

(3)  Check room sizing – refer specifications. Do not install if the actual room size is less than the specified 

minimum room size requirements.  

(4)  A dedicated 240V Earthed 10 Amp power point must be used with this heater. 
 

Notice to Victorian Customers:

 This appliance must be installed by a licensed person as required by the 

Victorian Building Act 1993. Only a licensed person will give you a compliance certificate showing that the 
work complies with all relevant standards. Only a licensed person will have insurance protecting their 
workmanship for 6 years. Make sure you use a licensed person to install this heater and ask for a 
compliance certificate. – Message from the Victorian Plumbing Commission. 

Preparation

Specifications

Features 

Summary of Contents for PG-311F













Reviews: