10
CALDERA E CORTEN FIRE PIT | Owner and Installation Manual
LIGHTING YOUR FIRE PIT
WARNINGS:
Failure to follow these instructions exactly may result
in fire or explosion causing property damage, personal
injury or loss of life.
Before operating the appliance, check all around the
appliance area and on the surrounding floor for the smell
of gas - some gas is heavier than air and may settle on the
floor in the event of a leak. IF YOU SMELL GAS, follow the
safety instructions on page 1 of this manual.
This appliance is equipped with an ignition device that
automatically lights the pilot. Do not try to light the pilot
manually.
The main gas valve in this appliance is not serviceable
and does not have any control knobs or switches to
operate. Do not remove the heat shields covering the
valve and electronic devices. Do not try to repair or modify
the valve, as doing so may result in a fire or explosion.
Call a qualified service technician if you have any safety
concerns.
Do not use this appliance if any part of it has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control
system and any gas control that has been under water.
Improper installation, adjustment, alteration, service or
maintenance can result in injury or property damage. For
assistance or additional information, consult a qualified
installer, service agency or the gas supplier.
Do not store or use gasoline or other flammable vapors or
liquids in the vicinity of this appliance.
INITIAL LIGHTING INSTRUCTIONS
Before placing burner assembly into a housing:
1. Purge air from the supply line.
2. Test for leaks in each of the following locations:
• The gas supply line connection to the main valve;
• The Burner connections and pilot;
• All joints on the valve and control body;
• All field made joints and gas shutoff valves;
• All factory made joints and connections.
3. You may check for gas leaks using one of the following methods only:
• Soap and water solution. WARNING: If using a soap and water solution to
test for leaks, DO NOT spray the solution onto electronic parts;
• An approved leak testing spray;
• An electronic sniffer. NOTE: Remove any excess pipe compound from
connections if using this method, as the compound can set off electronic sniffers.
DANGER: NEVER USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
