PALMSTIERNAS PMV EP5, Iom Instructions

Page: 7 / 42

7
Dependent on the local temperature variations, humidity and dew points and time in storage
condensation could occur and accumulate inside on the I/P Converter causing erratic opera-
tion or failure due to water and corrosion. The potential for condensation damage is especially
high in southern climates and aggravated if units are exposed to direct sunlight.
For further assistance, please contact you nearest PMV office.
Storage Seal (P5/EP5)
P5/EP5 is supplied with all enclosure entry points sealed.The seal is only a storage seal, not
to be used as seal when P5/EP5 is in operation. If Storage Seal is removed or damaged, make
sure all open enclosure entry points are proper resealed before further shipping or storage.
Use circular stickers marked I, S and OUT, supplied on Storage Seal or vapour proof tape.
P5
Remove Storage Seal from connection block, mount positioner on actuator/valve, make
connections according to section 5, (Page 10). Calibrate span and Zero according to section
7, (Page 13).
Clean any oil/debris off the connecting block, then reseal open enclosure entry ports, use
circular stickers marked I, S and OUT, supplied on Storage Seal or vapour proof tape.
EP5
Follow P5 instructions as above. Remove Storage Seal for conduit entry IE, connect input
signal cable and install proper cable gland to secure the units sealing.
P5-SEAL
IP5-SEAL
IP5 seal P5 seal