MAINTENANCE / REPAIR
TROUBLESHOOTING
OPERATION
ASSEMBLY / INSTALLATION
SAFETY / SPECIFICATIONS
GETTING STARTED
10
Interface Control Screen - Current Operations - F2
(Continued)
11
20
19
18
12
13
14
15
16
17
18. Count Trim Cut In or Out
Touch this button to count trim cut in or out after starting
automatic cutting cycle.
19. Feeding material length.
Refers to the current total length of material that has fed
forward. This includes distances beyond a single shuttle
stroke.
20. Preset Length: - refers to the length setting of the current
instruction task.
This chart below shows machine execution issues (17) and
remedies for them.
Execution messages
Remedy
Hydraulic pump OFF
Start hydraulic pump
Bench vise not clamping
securely
Close bench vise until indicator
light is on.
Front and rear vises are
clamping.
Open front vise or rear vise.
Zero setting incomplete
Execute zero setting.
Bow not released
Press bow rise button until
indicator light is on.
Choose execution No.
Touch the executive No. to
choose the cutting job.
Probe arm limit switch is off. Rise bow up.
Interface Control Screen - Cutting Jobs Settings - F3
21
22
23
24
25
26
27
28
The F3 button for will display the screen shown above.
21. Execution No.
Refers to the order of the cutting jobs No. from 1 to 10.
The machine will display the selected jobs currently
being performed in sequence from the top to the bottom.
Touch the execution number (NO.) to choose the cutting
jobs, the column will change its color to green.
The execution chart will not appear if the cutting quantity
has been finished or one of the columns (length or
quantity) is zero.
The F3 menu allows the user to set the variables for
workpiece cutting. There are 10 job slots available for
altering the production lengths and quantities.
Touch Job No. 1, to set the length and quantity.
Touch the Next button to go to the next page and so on
for the next available jobs.
To modify the cutting length (in manual mode) just touch
the length and the next screen (shown below) will be
displayed.
Touch the cutting length (in manual mode) to set a new
cutting length.
The numeric keypad will display (shown above) after
touching the cutting length.
This action allows users the capability to set the
variables for workpiece cutting.
Key in the cutting length and touch the Enter button to
finish the setting procedure.
