4
Palmgren Operating Manual & Parts List 9683295
ASSEMBLY
CONTROL BOX ARM
1. The control box arm arrives loose, with only the wires keeping it
attached.
2. Match the screw holes on lower box on the arm to the 4 holes on
the left side of the band saw, and screw the provided bolts in
until the lower box does not move.
LENGTH STOP
1. Locate all length stop parts. Long rod, L-shaped bracket-handle,
short rod with handle.
2. Fit the circular hole of the L-shaped bracket around the long rod.
3. Separate the short rod and its handle by unscrewing, and fit the screw
section through the slot of the L-shaped bracket. Then rescrew the
short rod’s handle back on to the short rod’s screw.
4. Match the long rod’s screw to the hole just beneath the vise as
shown below.
INSTALLATION
ELECTRICAL CONNECTIONS
WARNING:
Make sure unit is off and disconnected from power source
before any service or maintenance being made to the machine.
WARNING:
This machine must be grounded. To avoid electrocution or
fire, any repairs to electrical system should be done only by a qualified
electrician, using genuine replacement parts.
• The motor on this machine is designed for operation on the
voltage and frequency specified. Normal loads will be handled
safely on voltages not more than 10% above or below specified
voltage.
• Running the unit on voltages which are not within the range may
cause overheating and motor burn-out. Heavy loads require that
the voltage at the motor terminals be no less than the voltage
specified.
• A cable with three wires is equipped to connect your machine
into the 3-phase power supply. Please connect your machine into
the power supply with hand operated disconnecting device,
which is in compliance with sub-clause 5.3 of EN 60204 such as
no fuse breaker or plug/socket combination.
• The connection, disconnection and grounding is carried out
through the plug, equipped on the machine. For the safety
reason do not change this plug into any other type in any
situation.
• For the protection of control device, we recommend the operator
to supply a fuse with appropriate current rating, and the total
length between fuse and connection terminal shall not exceed 5
feet.
• The exact power source voltage, frequency and number of phase
shall be checked according to this manual and specifications.
WARNING:
Do not disconnect grounding terminal before
disconnecting power source.
ELECTRICAL SAFETY
• This machine must be grounded in accordance with the National
Electrical Code and local codes and ordinances. Any electrical
work must be handled by a professional, qualified electrician. To
help prevent and protect the user from shock, this machine must
be properly grounded.
• Confirm that power supply matches power requirements of the
machine before any electrical connection is made to the
machine. Before connecting the machine to a power source,
ensure that the switch is in the off position.
HANDLING & TRANSPORTATION OF MACHINE
WARNING:
Always keep balance of the machine in transportation.
Watch the gravity!
WARNING:
Drive forklift slowly and carefully.
• The total weight of this machine must be ensured before
handing.
• This machine cannot be handled without help of lifting tools.
Match long rod’s screw to hole just below vise.
Figure 1 - Electrical wiring panel.
Figure 2 - Transportation methods.
9683295_oipm_En012_9645931.01-0620 __ 07-02-2020 . . . .
