Palmgren Operating Manual & Parts List
80341A & 80342A
5
ASSEMBLY (CONTINUED)
•
Slide table bracket assembly with rack over column. Place bot-
tom end of rack inside beveled edge of column flange. See
Figure 5, page 4.
•
Slide retaining ring over column with beveled edge down.
Position ring against top of rack so that rack is in beveled edge
of ring. Secure ring with set screw.
•
Rotate table assembly around column. Adjust ring as necessary
to prevent binding of rack.
•
Attach crank handle onto worm gear shaft. Secure handle with
screw, tighten screw on flat of worm gear shaft.
MODEL 80342A
Refer to Figures 7 and 8.
•
Make sure worm gear is in the table bracket and engages pin-
ion teeth.
•
Place rack inside table bracket with large, unmachined portion
of rack to the top. Slide rack onto the slot in the bracket so that
rack teeth engage the pinion gear in the bracket.
•
Slide table bracket assembly with rack over column. Place bot-
tom end of rack inside beveled edge of column flange. See
Figure 7.
•
Slide retaining ring over column with beveled edge down.
Position ring against top of rack so that rack is in beveled edge
of ring. Secure ring with set screw.
•
Rotate table assembly around column. Adjust ring as necessary
to prevent binding of rack.
•
Attach crank handle onto worm gear shaft. Secure handle with
screw, tighten screw on flat of worm gear shaft.
•
Insert the extension arm into the table arm bracket assembly.
NOTE: The table can be installed directly to the table arm
bracket assembly.
•
Insert the table into the extension arm.
•
Tighten locking handles to secure table, extension arm and
bracket.
Figure 6 – Attach Retaining Ring, Crank Handle and
Locking Handle
Retaining Ring
Set Screw
Crank Handle
Figure 8 – Attach Extension Arm and Table
Bracket
Extension
Arm
Locking Handle
Table
Figure 7 – Attach Bracket, Rack, Retaining Ring and Crank
Handle
Retaining Ring
Set Screw
Bracket
Rack
Column Flange
Crank
Handle
