9
Palmgren Operating Manual & Parts List
80341A & 80342A
OPERATION (CONTINUED)
•
To return head to 0° vertical position, loosen head angle lock
handle, rotate guide pin 90° and tilt head. The guide pin will
snap into slot at 0° vertical. Secure in position by tightening
head angle lock handle.
•
To move head forward and backward, loosen head angle lock
handle. Turn head traverse knob until head is in desired posi-
tion. Secure head by tightening head angle lock handle.
•
To rotate head about the column, loosen head rotation lock
handle. Rotate head to desired position and secure by tighten-
ing head rotation lock handle.
TABLE ADJUSTMENTS
•
Height adjustments: To adjust table, loosen locking handle and
turn crank handle to desired height. Immediately retighten
table bracket locking handle.
•
Rotation of work table : Loosen table locking handle and
rotate table to desired position and retighten handle.
(Refer to Figure 7, page 5).
•
Tilting work table: Loosen hex head bolt. Remove pin and nut.
To do this, tighten nut until pin slips out easily. Tilt table to
desired angle up to 45° and retighten hex head bolt. Reinsert
pin and nut when returning the table to 0° position.
•
To obtain more distance between chuck and table, the work
table can be rotated 180° and base can be used as a work sur-
face. This permits drilling of larger objects.
•
Clamp table securely after adjustments have been made.
(See Figure 20).
DEPTH STOP ADJUSTMENT
Refer to Figure 21.
To control drilling depth, loosen hub locking knob and rotate hub
until the desired depth on scale coincides with the pointer. Tighten
knob to secure hub in position. Use this feature to drill more than
one hole to the same depth.
MOUNT DRILL BIT
WARNING:
Be sure drill press is turned off and is disconnected
from power source before adjusting speeds.
•
Place drill bit in jaws of drill chuck.
•
Tighten chuck with drill chuck key. Be sure to tighten the chuck
using all three key positions on the chuck body and remove
chuck key.
Figure 18 - Right Side of Head Assembly
Head Angle
Lock Handle
Head Traverse Knob
Reference Mark
Scale
Ram
Figure 19 - Left Side of Head Assembly
Guide Pin
Slot
Head Rotation
Lock Handle
Figure 20 - Tilting Worktable
Pin and Nut
Hex Head
Bolt
Figure 21 - Depth Stop Operation
Hub Locking Knob
Pointer
Scale
Hub
