Pallmann
Cobra
II
Manual
9
6
Disassembling for transport
For easy transportation the motor and the guide tube can be removed.
6.1
Removing the guide tube
Caution!
Injury to the operator or other persons could occur or damage could occur if the machine
starts up unintentionally. Disconnect the machine from the power supply before working
on the machine!
Instructions:
1.
Fold down the cable arm (3).
2.
Move the main lifting lever (2) to the front position in order to lower the sanding drum to the
floor. This removes the load from the control rod (5).
3.
Loosen both of the wing screws a little (4). Push the handle down to detach the control rod
(5) from the connector (8).
4.
Open the guide tube support (7) with the clamping lever (6) and pull the guide tube (1) out.
0
0
2
1
1
9
COBRA CLASSIC #74540
09/2014
5.1.1
Adjusting the handle height
1. Lower the main lifting lever ( 1 ) to the front.
2. Slide the clamp sleeve ( 2 ) to the top and take apart the connecting rod ( 3 ).
3. Loosen the clamp bolt ( 4 ).
4. Pull the locking stud ( 5 ) and have it snapped in at the desired position.
5. Assemble the connecting rod ( 3 ) on this position.
5.2
Mounting the dust pipe
Insert the dust pipe ( 1 ) into the pipe connection ( 2 ) while gently rotating it.
It is sealed with 2 O-rings.