Document #: 5100000 Revision: C
Page #: 17 of 20
8. DISCONNECTING BAG FROM MOTOR
8.1
Stop the motor by pressing STOP
(red)
button on speed display. Turn speed control
potentiometer to ZERO position by turning its knob all the way counterclockwise.
8.2
Press and release the main switch button on the control box. The button will stop
illumination indicating that the power is off.
8.3
Remove the clamp connecting the coupler with shaft adaptor.
8.4
Push the coupler down
away from shaft adaptor by 1-2 inches.
8.5
Reach the wand and push it down away from shaft adaptor until the hex head of the
wand is released from adaptor. Use small bearing on wand for better grip.
8.6
Once the hex head of the wand is released, raise the motor up 1-2 inches (
by
rotating the handle on the top of the motor positioner
) for better clearance from the bag.
8.7
Roll the tank with the bag out of the mixer’s frame.
8.8
Pull the wand from the sleeve holding plastic bushing inside the coupler.
8.9
Loosen thumb screws on the coupler, slide coupler out of the sleeve fitting.
8.10
Take plastic bushing out of the coupler.
8.11
Mixer is now ready to accommodate new mixing bag.
Summary of Contents for WandMixer RDUA003A
Page 19: ......
