Installing the Motherboard
8
4. Install Memory Modules
This motherboard accommodates
two 240-pin unbuffered DIMMs and supports DDR2 667/
533/400 DDR2 SDRAM. You must install at least one module in any of the two slots. Each
module can be installed with 1 GB of memory; the total memory capacity is 2 GB.
Do not remove any memory module from its antistatic packaging until you are
ready to install it on the motherboard. Handle the modules only by their
edges. Do not touch the components or metal parts. Always wear a grounding
strap when you handle the modules.
(1). This motherboard supports unbuffered DDR2 SDRAM only.
(2). Push the latches on each side of the DIMM slot down.
(3). Align the memory module with the slot. The DIMM slots are keyed with notches
and the DIMMs are keyed with cutouts so that they can only be installed
correctly.
(4). Check that the cutouts on the DIMM module edge connector match the notches
in the DIMM slot.
(5). Install the DIMM module into the slot and press it firmly down until it seats
correctly. The slot latches are levered upwards and latch on to the edges of
the DIMM.
(6). Install any remaining DIMM modules.
Refer to the following steps to install the memory modules.
Installation Procedure
