Palfinger PK9001-EH, Operator'S Manual, Page: 87 / 184

Chapter 6 Ancillary equipment
81
Assembling the pulley head:
x Put the main boom in horizontal position, outer boom in vertical position (refer 'Moving crane in
working position' in chapter 7)
x Extend the extension booms until approx. 50 cm (2 ft) before the pulley head.
1.
Put the connecting block into the extension boom.
2.
Fix the connecting block and secure it with the pin.
3.
Extend the extension boom until the connecting block can be attached to the pulley head.
4.
Attach the connecting block to the pulley head, lock the bolt.
5.
Rotate the pulley head upwards, until it is possible to fix it in the load lug.
6.
Fix the pulley head in the load lug, lock the pin.
1 1
1 3
1 4
1 5
1 6
2
x
Raise the outer boom to horizontal. Lower the main arm until it is possible to mount the
intermediate rollers.
x
Reel off sufficient rope.
x
Switch off crane.
x Reeve the rope.
x
Assemble the lower load block.
x Check rope guidance and rope.
x
While operating the winch the rope must run over all of the pulleys (additional rollers, guide
pulleys), etc.).
Danger!
If the rope is not properly reeved, this may lead to
damages. There is risk of injury or even fatal injury.
Example:
x Move the load arm to a working position.
Warning!
When mounting or dismounting the crane and while
moving it in transport or working position there is serious risk of
getting crushed!