14
translation
3.4 Automatic tightening of the V-
belts (Figure 8)
As the switch is released, the tightening wheel,
affected by spring C, presses the V-belts on the
slack side and the V-belts of the angular gear
and the blade shaft automatically remain at
correct tightness.
8
B
C
Fig. 8. Tightening the V-belts
3.5 Required measures in an emergency situation
If the clutch has been used in an emergency situation, e.g. when a log has stuck in the
circular saw-blade as a result of a mistake during the sawing, then immediately
disconnect the power take-off transmission of the tractor as well, because the pulley of
the angular gear can wear down the V-belts unnecessarily.
NOTE!
When the clutch is reset to the operating position, the power take-
off drive shaft must be disconnected from the tractor.
Only use the clutch in an emergency situation!
3.6 Selecting the operating mode: powered by tractor or electricity
(Figures 9 and 10)
The machine is equipped with a system to prevent simultaneous operation in two
modes.
When the cover plate is shifted to the left (Figure 9), it is possible to connect the
extension cable, and when it is shifted to the right (Figure 10), it is possible to
connect the power take-off shaft.
9
A
Fig. 9. Selecting the powered-by-
electricity mode
10
A
Fig. 10. Selecting the powered-by-tractor
mode
Summary of Contents for C700 COMBI
Page 38: ...34 translation 10 ELECTRIC DIAGRAMS ...
Page 39: ...35 translation ...
