Page 12.
The process of the device and, having detected any
malfunction, signal the electronics - which immediately
stops the device from working.
Airflow sensor Airflow sensor
analyzes the proper operation of
the fan and its
ability to
create the necessary air flow, as
well as the operational state
of the engine,
there is no
barrier to
atmospheric air intake to the
fan. If
The airflow sensor will not switch to a closed position,
control automation stops the start process and the red
button light signal (FAILURE) glows on the dashboard.
The cancellation signal is removed by pressing the red
button, and after it shuts down, the start attempt is
automatically repeated.
Flame ionization control
Ionization
of flame
control is responsible for
the
ignition
process, or the ignition
process. was a stick
of sparks
during the operation
of the
appliance
controls the presence of flames. If for any reason the
flame goes out, the controller immediately sends a
signal to automatic control, which in turn off the device
and the light signal glows in control panel. Red Button
(FAILED). The fault signal is removed by pressing the
red button. After that, the attempt is automatically
repeated. If the device does not turn on when you try to
restart, contact the service department.
Overeating sensor
The emphasis sensor is located
under the device's casing and
its function
is to constantly monitor the
temperature of the casing. If the
housing temperature reaches 134º,
the controller immediately sends a
signal to
control , which in turn off the device and the red button
light signal (FAILURE) glows in Control Panel. The
cancellation signal is removed by pressing the red
button, and after it shuts down, the start attempt is
automatically repeated.
Disable device
Disconnect the device in the following sequence:
-
Make sure all the buttons in Control Panel are
in
a
depressed state and the lights aren't on.
-
Close the gas tap in front of the machine.
-
Turn off the power to the appliance.
POSSIBLE FAILURES AND
METHODS OF ELIMINATION
The axial lover does not include possible
causes:
-
There's no power for the engine
-
Fuse failed in troubleshooting options:
-
Check the power supply
-
Replace the fuse. If the fuse fails, find the cause of
the overstatement.
There is no spark between the ignition electrodes
Possible causes:
-
There's no voltage between the ignition unit and the
electronics control unit
-
Too much space
with electrodes
to
ignite
-
Damaged capabilities for troubleshooting
control automation problems:
-
Clean the ignition electrodes
-
Check the electrical connection between the ignition
unit and the electronics control unit
-
Check the spark gap between the ignition electrodes
-
Replace control automation
The device does not work after the first ignition cycle
Possible causes:
-
The gas fountain is
closed
-
The pipeline is being broadcast
-
Inappropriate options for troubleshooting
noodles pressure :
-
Open the gas fountain
-
Blow up the pipeline
