PairGain 500L, User Manual

Page: 49 / 98

PRELIMINARY Chapter 6: Configuring Sessions
Megabit Modem 500L Installation Manual 41
PR
EL
IM
IN
A
RY
Defining Static NAT Entries
Static NAT entries are required only for applications that use TCP/UDP connections initiated
from the remote end (WAN). Through the
Static NAT Table , you can map inbound traffic from a
remote user to a user on your LAN. You can enter a maximum of 32 static NAT entries.
1 Do the following to map static NAT entries:
‹
Enter the Private IP Address for a user on the LAN that is mapped to the
Proxy IP Address you will enter in field
Œ
of the
Static NAT Entry
shown below.
Port is the logical port for the protocol (UDP or TCP) you select for this NAT entry .
Your system administrator will provide the protocol port number.
Œ
Enter the
Proxy IP Address
which is the IP address assigned to a particular session by
the service provider (see the

field on page 36 for where to find the proxy
IP address).
Port
is the logical port for the protocol (UDP or TCP) you select for this
NAT entry . Your system administrator will provide the protocol port number.
‹ Œ  Ž
