Painless Trail Rocker, Instructions Manual

Page: 45 / 62

41
RELAY OUTPUT WIRES
Route these wires to the location of your components. Ensure to route them
safely, and avoid high heat areas, moving parts, and sharp edges. Painless
recommends using grommets for any wires passing through metal to avoid
wearing through the wire insulation and causing arcing. Make sure any
accessories and/or components you install are properly grounded.
See Steps 51 – 55 starting on page 42 for a common example on connecting
the relay output wires to most accessories.
Relay Output Wire Color Diagram:
•
Switch #1: Grey/White
•
Switch #2: Blue
•
Switch #3: Yellow/White
•
Switch #4: Orange
•
Switch #5: Blue/Yellow
•
Switch #6: Purple
Extra Relay Output wires:
•
Wire #7: Pink
•
Wire #8: Green
Winch Control wires:
•
Winch Control In: White/Red
•
Winch Control Out: Brown/White
OPTIONAL:
If you wish to use the two extra wires (#7 Pink and #8 Green),
they will need to be wired into an additional switch. If you wish to double the
switch control wires on a single switch, thus allowing you to control 2 accessories
with 1 switch, then see
pages 27 – 28 for a step-by-step tutorial on achieving this.
For winch switch installation, see page 45 .