6
Step 5: Before mounting the Track Rocker Switch Panel, you may wish
to loom the Switch Panel Wires. We recommend
Painless
½”
PowerBraid (P/N: 70902)
.
Run the loom over the wire, and secure
the end of the loom with a zip-tie. Note: It isn’t necessary to loom
the entire wiring harness as you will cut these wires to length
later. Simply loom a few feet and make sure the end near the
switches is secure.
Step 6: The Switch Panel has a hole in each corner in order to mount
it to your selected surface. As these holes are not likely to exist
already, you’ll need to drill them out
Summary of Contents for Track Rocker series
Page 2: ......
Page 22: ...18...
Page 24: ...Painless Performance Products LLC 2501 Ludelle Street Fort Worth TX 76105 Phone 817 244 6212...
