6.2.1 Accessory Section B+ Connections
A. Connect the Accessory Section B+ wires according the Table 7.1.
WIRE CONNECTION INDEX
ACCESSORY SECTION B+
Color
Ga.
No.
Connect To
Function
Red
10
816
Battery Source
50001 Harness Power
Black
12
860
Ground
50001 Harness Ground
Purple
10
870
Starter Solenoid START
Starter Solenoid Activation
Gry/Wht
14
801
Cooling Fan
Cooling Fan Power
Ylw/Wht
14
847
Fuel Pump #1
Fuel Pump #1 Power
Green
14
863
Fuel Pump #2
Fuel Pump #2 Power
Brown
14
829
Tail Lights
Tail Lights Power (Not Relayed)
Blu/Ylw
14
807
Headlights
Headlights Power
Blue
14
862
Water Pump
Water Pump Power
Pink
14
820
Ignition Coil
Ignition Power
Orange
14
869
Accessory
Accessory Power
6.2.2 50201 Switch Panel.
A. Mount the switch panel in the desired location by drilling holes in the dash to suit your needs.
Use the four (4) mounting screws that are provided to secure the panel.
B. Insert the pre-terminated wires on the switch panel into the provided 12 way pin (male)
connector housing according to
Table 6.2
. Be sure you have threaded the wires through any
holes and grommets before installing the connectors. The electrical contacts are almost
impossible to remove without damage once they have been inserted into the connector body.
C. Using the proper crimping tool, install the provided (female) receptacle contacts onto the
50001 Instrument Panel Section wires according to
Table 6.2
and insert the contacts into the
connector plug provided. NOTE: We have provided you with 3 additional terminals in case
any become damaged during installation.
D. Connect the Switch Panel to the main harness and perform an operational check.
6.2.3 50202 Switch Box.
A. Mount the Switch Box in the desired location. Bolts or heavy screws are recommended.
Note:
The box is pre-punched to allow the Switch Box wires to exit from any chosen side. The
rubber grommet is provided to protect the wires as they exit from the box. Cap plugs are
included to plug the remaining unused holes for a finished look.
B. Attach the Switch Panel to the box with the four (4) screws provided, routing the wires out the
desired hole.
C. Insert the pre-terminated wires on the switch panel into the provided 12 way pin (male)
connector housing according to
Table 6.2
. Be sure you have threaded the wires through any
holes and grommets before installing the connectors. The electrical contacts are almost
impossible to remove without damage once they have been inserted into the connector body.
D. Using the proper crimping tool, install the provided (female) receptacle contacts onto the
50001 Instrument Panel Section wires according to
Table 6.2
and insert the contacts into the
connector plug provided. NOTE: We have provided you with 3 additional terminals in case
any become damaged during installation.
E. Connect the Switch Panel to the main harness and perform an operational check.
Table 6.1
Accessory Section B+ Connections
