1.0 INTRODUCTION
You have purchased what we at Perfect Performance Products, Inc. believe to be the most up-to-date and easiest-to-
install automotive racing wire harness or accessory on the market. It is designed for easy installation, even if you have
no electrical experience. PPPI Wire Harness Kits are designed to be used in vehicles with a General Motors-keyed
steering column, or other steering columns depending on the kit purchased. All wire is TXL (cross-linked
polyethylene), 600 volt, and 225ºf.
Standard automotive wire is GPT, 300 volt, 144º f. with PVC insulation.
The
50001
10
-Circuit Racing Wire Harness Kit
consists of two major groups:
DASH GROUP
Provides for switching of lights, two fuel pumps, water pump, cooling fan, start
and ignition, and an accessory.
ACCESSORY GROUP
Includes wires to connect tail and headlamps, ignition, fuel pumps, water
pump, cooling fan, and an accessory.
2.0 ABOUT THESE INSTRUCTIONS
These instructions provide information for the installation of the 50001
10
-circuit competition Wire Harness Kit,
and the 50201/50202
10
-circuit Switch Panel. The contents of these instructions are divided into major
Sections
,
as follows:
1.0
2.0
3.0
4.0
5.0
6.0
7.0
Introduction
About These Instructions
Tools Needed
Pre-Installation and Harness Routing Guidelines
General Installation Instructions
50001
10
-Circuit Racing Wire Harness Kit
50201/50202
10
-Circuit Switch Box/Panel
Sections are further divided into paragraphs and steps. Throughout, the
Figure
numbers refer to illustrations and the
Table
numbers refer to information in table form. These are located in or near the sections or paragraphs to which
they correspond. Always pay special and careful attention to any
Notes,
especially those in the tables, and any text
marked
CAUTION.
3.0 TOOLS NEEDED
In addition to your regular tools, you will need, at least, the following tools:
Crimping tool
Note:
Use a quality tool to avoid over-crimping.
Wire stripper
Continuity tester (Test light or ohm meter)
Electric drill
1-1/4" Hole saw
Small (10 amp or less) battery charger
4.0 PRE-INSTALLATION & HARNESS ROUTING GUIDELINES
The installation of your wire harness kit consists mainly in two parts:
The physical routing, positioning, and securing of the wire harness, wire groups, and individual wires.
The proper electrical connection of the individual circuits.
These two major tasks are not separate steps, but are integrated together. That is, you will route some wires and
make some connections, route some more wire and make some more connections.
We cannot tell you how to physically route the harness in your automobile. That depends a great deal upon the
particular make of automobile and, secondarily, to what extent you want to secure and conceal the harness. We do
offer some general guidelines and routing practices starting in
Paragraph 4.1
.
