![background image](http://html1.mh-extra.com/html/paia/vocal-zapper-6730/vocal-zapper-6730_assembly-and-using-manual_747070004.webp)
021402
4 Vocal Zapper
Solder each of the fixed resistors in place following the parts placement
designators printed on the circuit board and the assembly drawing (figure 1.).
Note that the fixed resistors may be mounted with either of their two leads in
either of the holes provided. Insert both leads in the mounting holes from the
non-foil side of the board, and push the resistor fully against the board. On the
conductor or foil side of the board, bend the leads outward to about a 45
degree angle to help hold the component in place while soldering. AFTER
SOLDERING, clip off each lead end flush with the top of the solder joint. Save
some of these clipped leads for use as wire jumpers in later steps.
DESIGNATION
VALUE COLOR CODE A-B-C
( ) R1
1K
brown-black-red
( ) R2
1K
brown-black-red
( ) R3
2.2K
red-red-red
( ) R4
22K
red-red-orange
( ) R5
47K
yellow-violet-orange
( ) R6
47K
yellow-violet-orange
( ) R7
47K
yellow-violet-orange
( ) R8
68K
blue-grey-orange
( ) R9
100K
brown-black-yellow
( ) R10
100K
brown-black-yellow
( ) R13
470K
yellow-violet-yellow
( ) R14
470K
yellow-violet-yellow
( ) R15
470K
yellow-violet-yellow
Fig 1
. Parts are mounted on the circuit board in the locations shown.