Pahlen Autodos M1, User Manual

Page: 10 / 35

10
Material = Polyester
Färg = Vit
Häftämne = 350
This
document
and
its
contents
are
the
exclusive
property
of
Pahléns
and
may
not
be
copied,
reproduced,
transmitted
or
communicated
to
a
third
party
,
or
used
for
any
purpose
without
written
permission.
Art.no.
Rev.no.
Scale
Designed by: Approved by:
Revised by: Date
Drawn by: Date
Drawing number
Assembly drawing no.
Surface treatment
part of ISO 2768-1
The tolerance class in accordance with this
E
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
TS TS
medel
2011-01-24
T.S 2011-02-17
Etikett Autodos M1-3
Installationshål
M11384
1:1
160 131 07
1
~230VAC Flow/Temp
CLE
CTE
Dosing
PB200
Redox
pH
35
180
ENGLISH
Autodos M
MA60-10E
ENGLISH
Autodos M
MA60-10E
GND free chlorine
Current input free chlorine (4–20mA)
24 VDC
Flow meter (white cable)/ – GND current outputs
Current output 1 (pH) 4–20mA (0–20mA)
Current output 2 (redox/chlorine) 4–20mA (0–20mA)
PNP in STDBY
Flow meter (green cable)/NPN in flow switch
PNP in, level switch (alarm upon closed input)
Flow meter (brown cable)/16 VDC PNP input
–GND Temperature sensor
Temperature sensor
Twin-cable communication with PC
Alarm (common)
de-energized state
230 VAC L
Acid/alkali dosing/chlorine dosing (free)
PB200 chlorine electrode
Chlorine electrode CLE2.2
GND
V–
V+
Connection of ProMinent CLE 3-mA 10ppm
Terminal 1 (+) to terminal 26
Terminal 2 (–) to terminal 27
Accessories
Modelbus RTU
9600 band, Parity None
Example D:
Current out-
put controlled
dosing pump
Example A:
On/Off
controlled
dosing pump
Example C:
Frequency
controlled
dosing pump
Installation, electrics
Electrical installation must only be carried out by an authorized electrical installation technician.
Electrical installation must be performed after pipe installation is complete.
The equipment must be permanently grounded and monitored by a residual current device (RCD) with a maximum leakage
current of 30 mA.
The equipment should be supplied via an additional 2-pin switch.
Inputs/outputs for cables as per figure below.
View from below
The following example shows how connections are to be made
Connection example
Connection example - Autodos M1