SERVICING & REPAIRS
SECTION 5
5.1
WARNING: To reduce the risk of electric shock, do not attempt any servicing
or repairs unless you are qualified to do so. Refer all servicing or repairs to
qualified servicing personnel. The charger contains advanced electronics that
do not require periodic maintenance. Consequently there are no user-
serviceable parts inside.
5.2
Qualified electronics engineers who wish to gain access to internal assemblies
should note that parts of the power circuit retain a high voltage even after the
mains supply has been disconnected. Wait for a period of five minutes
following disconnection before commencing disassembly, and be aware of
charged capacitors.
5.3
When the charger is correctly connected to a mains supply and the display is
not functioning, it may be that a supply fuse has become open circuit.
Equipment supplied for use in the UK is supplied with a standard UK mains
cordset, complete with a moulded, fused plug. If this fuse has become open
circuit it should be replaced by another of the correct rating (see
‘Specification’ section 2.12). USE ONLY A FUSE OF THE CORRECT RATING.
If the replacement of the fuse fails to correct the above symptoms, do not
attempt further fuse replacement. It is likely that a fault has developed.
Seek advice from your nearest PAG dealer or direct from PAG Ltd., London,
by telep44 (0)20 8543 3131.
5.4
The chargers feature a fail-safe shutdown mode. In the unlikely event of an
internal malfunction, an error message will be displayed on the screen. This
could be the result of any number of undesirable situations from which the
system is protecting itself, such as the obstruction of ventilation slots,
causing inadequate cooling, or the microcomputer’s detection of an internal
fault. In these cases the charger should be disconnected from the supply,
any obstruction of the air vent system removed, and the unit allowed to cool
before reconnecting to the supply. Should the charger re-enter the fail-safe
shutdown mode, more detailed investigation is required. Make a note of the
error message and seek advice from your nearest PAG dealer or direct from PAG
Ltd., London, by telep44 (0)20 8543 3131.
5.5
Unqualified personnel should not attempt further investigation (see paragraph
5.1 above). Any such interference would invalidate the guarantee and
invariably cause more damage than the original fault.
10
Summary of Contents for PAGlink pl16+
Page 1: ...Instruction Manual PL16 CHARGER JAN 2016 ...
Page 2: ......
